首页 > 产品中心| Radio and Cassette Recorder Circuit | |||||
| Part No. | Features | Supply Voltage | VDD/VCC | Package | |
| PD(mW) | FAM(MHZ) | FFM(MHZ) | |||
| LM8560 | Digital Alarm Clock | -15.0V ~ 0.3V | VDD=-14.0V ~ -7.5V | SDIP-28 | |
| 700mW | - | - | |||
| TS2043 |
4 -WireTouch Panel controller * Power Supply Voltage: 2.7V ~ 5.5V * Serial Interface * 4-Wire Touch Panel Interface * Embedded Touch Panel Drivers * 12-Bit AD Converter * Programmable 8 or 12 Bit Resolution * Conversion Rate: 125 KHz * 2 Auxiliary Analog Inputs * Full Power Down Control |
-0.3V ~ 6.0V | VCC= 2.7V ~ 5.5V | SSOP-16 | |
| - | - | - | |||
| L2572 |
Wideband Pll FM Demodulator * Constant voltage and constant current control * Single chip PLL system for wideband FM demodulation * Simple low component count application * Allows for application of threshold extension * Fully balanced low radiation design * High operating input sensivity * Improved VCO stability with variations in supply or temperature * AGC detect and bias adjust * 75Ω video output drive with low distortion levels * Dynamic self biasing analog AFC * Full ESD Protection |
-0.3V ~ 7.0V | VCC= 4.5V ~ 5.5V | SOP-16 | |
| 250mW | - | - | |||
| LAG665F |
1-Chip Radio and Cassette Circuit Recorder. *1-Chip stereo tape recorder with motor speed controller. *Operating supply voltage range: VCC=2~5V *Good volume control |
-0.3V ~ 7.5V | VCC= 3.0V | SOP-28 | |
| 450mW | GVO=72dB | CT=30dB | |||
| TS20 |
2.4V, 10uA Analog Temperature Sensor * Power Supply Voltage:2.4V ~ 5.5V * 2.5°C Accuracy * 10uA MAX. Current Consumption * Temperature Range -55°C to +130°C * Predictable Curvature Error * Suitable for Remote Applications |
-0.2V ~ 6.5V | VCC= 2.4V ~ 5.5V | SOT-25 | |
| - | - | - | |||
| TDA7088 | FM Receiver Circuit for Battery Supply | 5.0V | Vcc=3.0V (RL=22kΩ) | SOP-16 | |
| - | Firf=0.5~110MHz | Vo(rms)=85mV | |||
| 7642 |
1-Chip AM Radio Circuit *Low operating voltage: Down to VCC=1.3V *Low Quiescent Current: ICCO=0.2mA *Low external component required. |
6.0V | Vcc=1.2V ~ 1.6V | TO-92 SOT-23 | |
| - | - | - | |||
| 6610 |
Frequency and Clock Display Driver * FM input with pre-scalar for radio frequency up to 150 MHz * AM input for radio frequency up to 30 MHz * 3 common, 13 segment, 1/3 bias LCD display drivers which supports 4 digits LCD display * On chip oscillator for external 32.768kHz crystal * 10.7 MHz / 70 kHz I.F. frequency offset for FM signal and 455kHz I.F. frequency offset for AM signal * Internal real time clock in 12 hour display mode * Selectable clock or frequency display * 1.8V to 3.3V supply voltage |
7.0V | VDD=3.0V | QFP-48 | |
| - | 0.5~30.0(MHz) | 11.0~150.0(MHz) | |||
| TA2003* | AM/FM Radio IC | 8.0V | VCC= 3.0V | DIP-16 SOP-16 | |
| 750mW/350mW | S/N=43dB | S/N=62dB | |||
| TA7640APL* | AM/FM IF Processor | 8.0V | VCC= 5.0V | DIP-16 | |
| 750mW | S/N=47dB | S/N=65dB | |||
| CXA1191 | AM/FM Radio | 9.0V | VCC= 6.0V | DIP-28 SOP-28 | |
| 1000mW/700mW | Gv2(1660KHz)=22dB | Gv1(100MHz)=39dB | |||
| KA22427 |
1-Chip AM/FM Radio Circuit *Low external components count. *Wide operating voltage : 3 - 13 V. *Internal regulated supply for constant current operation. *DC selection of AM/FM mode. |
11.0V | VCC= 5.5V | DIP-16 | |
| 600mW | S/N=20dB | GV=40dB | |||
| TA7613AP |
1-Chip AM/FM Radio IC *Low external components count. *Wide operating voltage: 3 - 13 V. *Internal regulated supply for constant current operation. *DC selection of AM/FM mode. |
11.0V | VCC= 5.5V | DIP-16 | |
| 600mW | S/N=20dB | GV=40dB | |||
| A6043 |
FM Stereo Multiplex * Low and wide operation: VCC= 3V~12V * High pilot lamp ON sensitivity: VL(ON) = 9mVrms (Typ.) * Suitable for LED driving: ILAMP = 20mA (Max.) * Recommendable input voltage range: VIN = 200~700mVrms * Low distortion: THD = 0.08% (Typ.) at VIN = 200mVrms(Stereo) * VCO stop capability stereo lamp and turn off are simultaneously operated by connect pin 7 to VCC. * Easy adjustment (The monitored free running frequency of VCO is 38kHz at pin 6.) |
12.0V | VCC= 8.0V | SIP-9 | |
| 500mW | Gv=0.5dB | Cs=45dB | |||
| A6225 |
Dual Pre-Amplifier * Dual pre amplifier for cat or home stereo use. * High voltage gain: GVO = 100dB (Typ.) at f= 1kHz. * Excellent channel separation and high ripple rejection : CS = 65dB(Typ.) (f = 10kHz, RG = 2.2kΩ, VOUT= 0dBm) : RR = 50dB(Typ.) * Low noise: VNI = 1.0μV(Typ.) at RG = 2.2kΩ, Bw =20Hz~20kHz * Wide operating supply voltage range: VCC = 6~16V (TA = 25°C) |
16.0V | VCC= 6.0V | SIP-9 | |
| 700mW | GVC=41.5dB | Cs=65dB | |||
| BA3308 |
Dual Pre-Amplifier with ALC * Wide operating power supply voltage range (VCC =4.5V ~ 14V) * Power-on mute circuit to avoid “pop” noise generation. * No input coupling capacitors are necessary * High gain (GVO=80dB)and low noise (VNIN=1μVrms) * Low distortion (THD=0.1%) * Good ALC channel balance with built-in ALC rectifier diode * Adjustable ALC dynamic range by external input resistor. |
16.0V | VCC= 7.0V | SOP-14 SIP-9 | |
| 450mW/950mW | GVO=80dB | Cs=75dB | |||
| KA22241 |
Dual Equalizer Amplifier with ALC * Dual equalizer amplifier with built-in ALC circuit * Low noise VNI=1.0μV(Typical) * High open loop voltage gain: Gv=80dB(Typical) * Good ALC response balance between channels * Not necessary the input coupling capacitor * Not necessary the diode or transistor for ALC * Built in power supply muting circuit * Minimum number of external parts required |
16.0V | VCC= 7.0V | SOP-14 SIP-9 | |
| 450mW/550mW | GVO=80dB | - | |||
| UTC571N |
Compandor * Complete compressor and expandor in one Chip * Temperature compensated * Greater than 110dB dynamic range * Operates down to 6VDC * System levels adjustable with external components * Distortion may be trimmed out * Dynamic noise reduction systems * Voltage-controlled amplifier |
6.0V ~ 18V | VCC= 5.0V | SOP-16 SOP-16(W) | |
| 400mW/625mW | - | - | |||
| ULA1145 |
FM IF System (Quadrature Detector) For Car Radio * Built-in IF count buffer circuit and microprocessor-controlled switch circuit for ETR * High S/N * Wide range output * More simplifies design: - Built-in SD circuit—regulable sensitivity independently of soft mute characteristics - Variable S-meter gradient—output with three pins |
6.0V ~ 18V | VCC= 8.0V | HTSSOP-20 | |
| 630mW | - | - | |||
|
|
|||||
