首页 > 产品中心| Miscellaneous | |||||
| Part No. | Features | VCC | ICC | GV(dB) | Package |
| PD(mW) | IOUT | IEP | |||
| HC2210 | Dual Voltage Quick Heat Controller | 3.5V ~ 5.5V | 500uA | - | DIP-8 SOP-8 |
| 500mW | 20mA | - | |||
| L88312 |
SHORT CIRCUIT PROTECT BLOCK FOR LNB * Wide operating voltage range: 8V~32V * Low on resistance:320 mΩ * Constant current set by external resistor * Thermal shutdown |
8~32V | <6mA | - | SOP-8 |
| - | Typ=0.37A | - | |||
| A2804 |
Zero Voltage Switch *Easy operation either through the AC line or a DC supply. *Supply voltage control. *Very few external components. *Symmetrical burst control-No DC current components in the load circuit *Negative output current pulse up to 250mA-short circuit protection. *Reference voltage output |
8.2V | - | - | DIP-8 SOP-8 |
| 350mW | 180mA | - | |||
| A6966 |
5 DOT LED Level Meter * Low Spurious Noise Operation. * Constant Current Output: IOUT=8mA (Typ.) * Indication Level Steps: 5dB, 5dB, 3dB, 3dB * Wide Operating Supply Voltage Range: VCC = 4~ 12V * Variable Input Amplifier Gain: GV = 0 ~ 20dB |
14.0V | 5mA | 0 ~ 20dB | SIP-9 |
| 600mW | 8mA | - | |||
| LA2284/A |
5-DOT Dual LED Level Meter Driver *High gain rectifying amplifier included (Gv=26dB) *Low radiation noise when LED turns on *Logarithmic indicator for 5-dot LED of bar type *Constant current output(15mA) *Wide operating supply voltage *Not necessary diode or transistor for ALC *Minimum number of external parts required |
3.0V/3.5V ~ 16.0V | 8mA | 24 ~ 28dB | SIP-9 MSOP-10 |
| 1100mW | 11.0 ~ 18.5mA | - | |||
| UA8316 |
IGBT Gate Driver * A high current can directly drive IGBT * Can directly control from a microcontroller Source current: -200mA (max), sink current 1A (max) * Protect the IGBT gate at power on via a diode |
7.0V ~ 24.0V | GATEIN=L 8.8mA | - | SIP-7 |
| 925mW | - | - | |||
| 6621 |
RAM MAPPLING 32×4 LCD CONTROLLER FOR I/O μC * Operating voltage range: 2.4V~5.2V * External 32.768kHz crystal or 256kHz frequency source input * Built-in 256kHz RC oscillator * Internal time base frequency sources * Two selectable bias (1/2 or 1/3), and three selectable duty LCD applications (1/2 or 1/3 or 1/4). * Two selectable buzzer frequencies (2kHz/4kHz) * Power down command reduces power consumption * Built-in time base generator and WDT * Time base or WDT overflow output * 32×4 LCD driver * 8 kinds of time base/WDT clock sources * Built-in 32×4 bit display RAM * 3-wire serial interface * Software configuration feature * Internal LCD driving frequency source * Data mode and command mode instructions * VLCD pin for adjusting LCD operating voltage * R/W address auto increment * Three data accessing modes |
2.4V~5.2V | - | - | DIP-28 SSOP-24 |
| - | - | - | |||
| UL316 |
SERIAL-INTERFACED 6-DIGIT LED CONTROLLER IC WITH KEYSCAN * LED driver with 14 outputs (8 segments/6 digits)×40 mA load current capability for each segment * Output pins connected directly to the LEDs or can be open-drain * Key-scanning (8 x 2 matrix) * 3-wire serial bus interface (CLK, STB, DIN/DOUT) * 8-step dimming circuit to control the overall display brightness * Single external resistor for output current setting * Inputs with Schmitt trigger give superior noise immunity * A single LED digit output (DIG1_LED) can be used to drive up to 8 discrete LEDs * 8-step dimming circuit to control brightness of individual LEDs for LED digit * 5.0 V (± 10%) for VCC * Drives common-anode LED digits * Built-in power on reset and soft-start circuits |
4.5V~5.5V | TYP=10mA | - | SOP-24 |
| 1200mW | IDIG = TYP320mA | - | |||
| U8C3005 |
8 BIT SERIAL-IN PARALLEL-OUT VALVE DRIVER * VDD range: PVDD 8V to 30V * each channel current limit: 50mA * Integrated internal 6V regulator * Maximum clock frequency: 0.5MHz * Built-in open/short detection * Short protect * Detecting response * Internal reverse diode of PVDD to Absorb reverse current from coil |
8.0V~30.0V | TYP=3.2mA | - | SOP-16 |
| 1000mW | - | - | |||
| U8C3525 |
8 BIT SERIAL-IN PARALLEL-OUT VALVE DRIVER *VDD range: VDD 5V to18V PVDD 5V to 35V *Maximum clock frequency: 1MHz *current limit of Each channel:250mA *Built-in open/short detection *Short protect *Detecting response *Internal reverse diode of PVDD to Absorb reverse current from coil |
5.0V~18.0V | TYP=2.3mA | - | SOP-16 |
| 1000mW | 250mA | - | |||
| TL2494 |
CC CONTROL FOR CAR BALLAST * 6 ~ 40V input * UVLO * Open circuit protect * Overload protect |
6.0V~40.0V | TYP=14mA | - | SOP-16 |
| 1000mW | - | - | |||
| VF8143 |
LOW-COST Three-Channel 4TH-ORDER STANDARDDEFINITION VIDEO FILTERS * Three-Channel 4th-order 8MHz filters for SD video * Transparent input clamping * AC-or DC-coupled inputs * AC-or DC-coupled outputs * Drives single, +6dB output (150Ω) * Drives dual, +6dB output (75Ω) * DC-coupled outputs eliminate AC-coupling capacitors * Single +5V power supply * Robust 8kV ESD protection |
4.75V~5.25V | TYP=19mA | - | SOP-8 |
| - | - | - | |||
| VF8146 |
LOW-COST SIX-CHANNEL 4TH-ORDER STANDARDDEFINITION VIDEO FILTERS * Six-Channel 4th-order 8MHz filters for standard-Definition video * Transparent input clamping * AC-or DC-coupled inputs * AC-or DC-coupled outputs * Drives single, +6dB output (150Ω) * Drives dual, +6dB output (75Ω) * DC-coupled outputs eliminate AC-coupling capacitors * Single +5V power supply |
4.75V~5.25V | TYP=35mA | - | TSSOP-14 |
| - | - | - | |||
| VF8148 | TRIPLE VIDEO DRIVER WITH SELECTABLE HD/SD VIDEO FILTERS FOR RGB OR YUV SIGNALS | 4.75V~5.25V | TYP=45mA | - | DIP-16 |
| - | - | - | |||
| USA575 |
LOW VOLTAGE COMPANDOR * Operating voltage range from 3V to 7V * Reference voltage of 100mVRMS=0dB * 600Ω drive capability * One dedicated summing op amp per channel and two extra uncommitted op amps * Single or split supply operation * Wide input/output swing capability |
3.0V~7.0V | TYP=4.2mA | - | SSOP-20 TSSOP-20 |
| - | - | - | |||
| IR8511 |
IR FILTER SWITCH DRIVER * 1.8V input driving pulse * Low standby Current: IQSC<10uA * 2.5V~5.5V operating voltage range * Only one control input and Built-in non-overlap circuit to avoid the MOSFET damage caused by the fast output voltage transient |
2.5V~5.5V | TYP=1mA | - | SOT-26 |
| - | 500mA | - | |||
| UCHQ200 |
USB DEDICATED CHARGING PORT CONTROLLER WITH QC 2.0 FAST CHARGING FUNCTION * Fully Supports Quick Charge 2.0 specification: Class A: 5V, 9V, 12V Output Voltage. Class B: 5V, 9V, 12V, 20V Output Voltage. * Supports USB DCP Shorting D+ Line to D- Line per USB Battery Charging Specification, Revision 1.2. * Meets Chinese Telecommunication Industrial Standard YD/T 1591-2009. * Supports USB DCP applying 2.7V on D+ line and 2.7V on D- line. * Supports USB DCP applying 1.2V on D+ and D- lines. * Automatic selection of D+/D- mode for an attached device. *Compliant with Apple and Samsung devices. |
4.0V~6.0V | TYP=0.6mA | - | SOP-8 |
| - | 500mA | - | |||
| UCHQ613 |
USB DEDICATED CHARGING PORT CONTROLLER * Supports USB DCP Shorting D+ Line to D– Line per USB Battery Charging Specification, Revision 1.2 (BC1.2) * Supports Shorted Mode (Shorting D+ Line to D-Line) per Chinese Telecommunication Industry Standard YD/T 1591-2009 * Supports USB DCP Applying 2.7V on D+ Line And 2V on D-line (or USB DCP Applying 2V on D+ Line and 2.7V on D– Line) * Supports USB DCP Applying 1.2V on D+ and D– Lines * Automatically Switch D+ and D- Lines Connections for an Attached Device * Dual USB Port Controller, UCHQ613 * Operating Range: 4.5V to 5.5V |
4.5V~5.5V | TYP=0.155mA | - | SOT-26 |
| - | 35mA | - | |||
| URYD21 |
300mA BI-DIRECTION RELAY DRIVER * Supports USB DCP Shorting D+ Line to5 to 36V input voltage range * Low Power Consumption (IQ<1uA) * Input High Level Threshold: 3V, compatible with * most single chip microcontroller * Typical Driving Current: 300mA * Rds(on)=15ohm(Vin=12V, PMOSFET+NMOSFET) * Rds(on)=10ohm(Vin=20V, PMOSFET+NMOSFET) * Peak Driving Current: 500mA@Vin=24V * Environment Temperature: -40°C~85°C |
5.0V~36.0V | 0.001mA | - | SOT-26 |
| - | 300mA | - | |||
| ULS4X2 |
4X2 SWITCH MATRIX WITH TONE/POLARITY CONTROLLER n DESCRIPTION The UTC ULS4X2 is a low-cost 4 x 2 switch matrix with tone detector in a 20-lead QFN package. It is used in RF multiplexing applications from 200 to 3000 MHz. There is a 4 bit decoder and tone/polarity detector integrated with RF switch which can reject DiSEqC control signals. Switch may be used in 50/75 ohm systems. Both switch outputs (OP1 & OP2) can independently select any of the four inputs (HH, HL, VH, VL) or simultaneously select the same inputs. Note that the switch is bi-directional and input/output functionality may be interchanged. |
3.0V~4.2V | TYP=2.0mA | - | QFN-20(4x4) |
| - | - | - | |||
| ULN2008 |
* Output current (single output): 100mA (MAX.) * High sustaining voltage output: 50V (MIN.) * Output clamp diodes * TTL/CMOS logic level is compatible. |
50V | 2.5mA | - | SOP-16 |
| 1500 | 100mA | - | |||
| ULN2010 |
* Output current (single output): 100mA (MAX.) * High sustaining voltage output: 50V (MIN.) * Output clamp diodes * TTL/CMOS logic level is compatible. |
50V | 2.5mA | - | SOP-16 |
| 1500 | 100mA | - | |||
| TS2043 |
4 -WireTouch Panel controller * Power Supply Voltage: 2.7V ~ 5.5V * Serial Interface * 4-Wire Touch Panel Interface * Embedded Touch Panel Drivers * 12-Bit AD Converter * Programmable 8 or 12 Bit Resolution * Conversion Rate: 125 KHz * 2 Auxiliary Analog Inputs * Full Power Down Control |
2.7~3.6 | 300uA | - | SSOP-16 |
| 800 | - | - | |||
| TS20 |
2.4V, 10uA Analog Temperature Sensor * Power Supply Voltage:2.4V ~ 5.5V * 2.5°C Accuracy * 10uA MAX. Current Consumption * Temperature Range -55°C to +130°C * Predictable Curvature Error * Suitable for Remote Applications |
2.4~5.5 | - | - | SOT-25 |
| - | 10mA | - | |||
| UVXS0102 |
2-BIT BIDIRECTIONAL VOLTAGE-LEVEL TRANSLATOR FOR OPEN-DRAIN AND PUSH-PULL APPLICATIONS * Maximum Data Rates 24 Mbps (Push Pull) 2 Mbps (Open Drain) * 1.65V~3.6V on A ports and 2.3V~5.5V on B ports (VCCA≤VCCB) * No Direction-Control Signal Needed * VCC Isolation Feature: If either VCC input is at GND, both ports are in the High-Impedance state * No Power-Supply Sequencing Required: Either VCCA or VCCB can be ramped first * Ioff Supports Partial-Power-Down Mode Operation |
Vcca: 1.65~3.6 Vccb: 2.3~5.5 |
Icca: 2.4uA Iccb: 14.4uA |
- | SOP-8 |
| - | 50mA | - | |||
|
|
|||||
