首页 > 产品中心| Automotive IC | |||||
| Part No. | Features | VCC | Package | ||
| PD(mW) | |||||
| 93334 |
High Energy Ignition Circuit * Very Low Peripheral Component Count * No Critical System Resistors * Wide Supply Voltage Operating Range (4.0V ~ 24V) * Overvoltage Shutdown (30V) * Dwell Automatically Adjusts to Produce Optimum Stored Energy without Waste * Externally Adjustable Peak Current * Transient Protected Inputs and Outputs |
4.0V ~ 24.0V | SOP-8 | ||
| 1050mW | |||||
| UU6043B |
Single Output Flasher IC for 18mohm shunt Temperature and supply voltage compensated frequency * Warning indication of lamp failure by means of frequency doubling * Relay driver output with high current carrying capacity and low saturation output * Minimum lamp load for flasher operation: ≥ 1 W * Very low susceptibility to EMI |
9.0V ~ 15.0V | SOP-8 DIP-8 | ||
| 340mW/420mW (95℃) | |||||
| U2043 |
Flasher, 30 mΩ Shunt, Pilot Lamp to GND or Vbatt *Temperature and voltage compensated frequency *Warning indication of lamp failure by means of frequency doubling * Minimum lamp load for flasher operation ≥10 W *Relay output with high current carrying capacity and low saturation voltage *Low susceptibility to EMI |
9.0V ~ 15.0V | SOP-8 DIP-8 | ||
| 340mW/420mW (95℃) | |||||
| L2044 |
Dual Output Flasher * Temperature and Supply Voltage Compensated Flashing Frequency * Frequency Doubling Indicates Lamp Fault. * Two Relay Driver Outputs with High Current-carrying Capacity and Low Saturation Voltage * Minimum Lamp Load for Flasher Operation: ≥ 1W * Very Low Sensitivity to EMI * Extremely Low Current Consumption<10μA ( at Switches Open) * Reverse Polarity Protection * Three Control Inputs: Left, Right and Hazard Warning |
8.0V ~ 18.0V | DIP-14 SOP-14 | ||
| PL=1.0W(Min) | |||||
| LL204 |
Dual Output LED Flasher Controller * Temperature and supply voltage compensated flashing frequency * Frequency doubling indicates lamp fault. * Two relay driver outputs with high current-carrying capacity and low saturation voltage * Minimum lamp load for flasher operation: ≥ 1W * Very low sensitivity to EMI * Extremely low current consumption<10μA ( at switches open) * Reverse polarity protection * Three control inputs: left, right and hazard warning |
8.0V ~ 18.0V | DIP-14 SOP-14 | ||
| PL=1.0W(Min) | |||||
| M4213 |
Ignition Controller of Motorcycle * Power supply by magnetoelectric motor and clamping at 9.2V * Less external components and wide applicability * Low static current, typical is 5mA * High quality and stability for using 5μm Bipolar process |
9.0V ~ 9.5V | DIP-14 SOP-14 | ||
| - | |||||
| UU6032B |
Automotive toggle switch IC * Relay driver with Z-diode * RC oscillator determines switching characteristics * Debounced input for toggle switch * Three debounced inputs: ON, OFF and TOGGLE * RF interference protection * Load-dump protection |
6.0V ~ 16.0V | SOP-8 DIP-8 | ||
| 340mW/420mW (95℃) | |||||
| UU6046B |
Rear window heating timer * Delay time range: 3.7s to 20h * Relay driver with Z-diode * RC oscillator determines switching characteristics * Debounced input for toggle switch * Two debounced inputs: ON and OFF * Load-dump protection * RF interference protected * Inputs switched to VBatt |
6.0V ~ 16.0V | SOP-8 DIP-8 | ||
| - | |||||
| UU6047B |
Rear window heating timer * Delay time range: 3.7s to 20h * Relay driver with Z-diode * RC oscillator determines switching characteristics * Debounced input for toggle switch * Two debounced inputs: ON and OFF * Load-dump protection * RF interference protected * Inputs switched to ground |
6.0V ~ 16.0V | SOP-8 DIP-8 | ||
| - | |||||
| UU642 |
Wiper Controller Wipe; Wash; Interval modes * After-wiping time: 2s~20s * Interval pause: 4s~20s * Wipe/wash mode priority * Wiper motor’s park switch * Relay driver with Z-diode * One external capacitor determines all time sequences * Interference protection according to VDE 0839 or ISO/TR 637/1 * Load-dump protected |
9.0V ~ 16.5V | SOP-8 DIP-8 | ||
| 500mW | |||||
| UAC33092 |
Alternator Voltage Regulator *Forced Load Response Control (LRC) with Heavy Load Transitions at Low RPM *Capable of Regulating Voltage to ±0.1 V @ 25℃ *Operating Frequency Selectable with One External Resistor *< 0.1 V Variation over Speed Range of 2000 to 10,000 RPM *< 0.4 V Variation over 10% to 95% of Maximum Alternator Output *Maintains Regulation with External Loads as Low as 1.0 A *Load Dump Protection of Lamp, Field Control Devices, and Loads *Duty Cycle Limit Protection *Provides High Side MOSFET Control of a Ground Referenced Field Winding *Controlled MOSFET and Flyback Diode Recovery Characteristics for Minimum RFI *Optional 2.5 or 10 sec. LRC Rate Control (Osc. Freq. = 280 kHz) *Undervoltage, Overvoltage and Phase Fault (Broken Belt) Detection |
11.5V ~ 16.5V | SOP-20 SOP-24 | ||
| 867mW/1000mW | |||||
| UAC33092A |
Alternator Voltage Regulator * Forced load response control (LRC) with heavy load transitions at low RPM * Voltage regulated to ± 0.1V @ 25°C * External resistor adjustable operating frequency * Regulation is effective with loads as high as 1.0A * Load dump protection of lamp, field control devices, and loads * Undervoltage, overvoltage , phase fault (broken belt) detection and duty cycle limited protections |
11.5V ~ 16.5V | SOP-20 | ||
| 867mW | |||||
| UL497 |
Hall Effect Pickup Ignition Controller * Direct driving of the external power darlington * Coil current charent charging angle control * Programme coil current peak limitation * When 94% nominal current not reached programmable dwell recovery time * RPM output * Has peranent conduction protection * Overvoltage protection * Internal supply zener * Reverse battery protection |
6.8V ~ 8.2V | SOP-16 | ||
| 1200mW | |||||
| UU4761 |
FLASHER IC * The static operating current<5mA * Wide operating voltage range * Very low susceptibility to EMI |
9.5V ~ 18.0V | DIP-8 SOP-8 | ||
| - | |||||
| UU4793 |
Overload Monitoring with Resistive Load, VT = 44.5 mV * Two common reference comparators * Tight threshold tolerance * Constant threshold * Output with NPN * 8 kV - ESD protection * Protection of reverse polarity * Load-dump protection |
9.0V ~ 15.0V | SOP-8 | ||
| 360mW(95℃) | |||||
| UL9480 |
A VOLTAGE REGULATOR FOR CAR ALTERNATOR * No external components * Precise regulated voltage * High output current * Very low start voltage * Precise temperature coefficient * Short circuit protection * Output current limit * Reverse battery protection * +80V Load dump protection * Low energy spike protection * Over temperature protection |
80.0V | TO-220 | ||
| - | |||||
|
|
|||||
